i was out on my yz125 and i noticed i had no coolent in panic i went home and toped up i came back out and later i went home and found there was no coolent in it what could it be
that is the problem I don't have a couple I need to go buy one but I didn't want to buy a whole set right now Just thought maybe someone might own a crf150 and would know off the top of their head. Thanks anyway.
Put a large crescent wrench on it and then measure the gap. Fold a piece of paper over it and measure the fold. Crawl under your bike with a metric ruler or lay it down and you know the rest.
that ought to do it for you.
check your oil if it is white then u have a broken seal somewhere and thats where ya water is going...some times if u fill an emty rad it will only fill half cos and when u run it fills the other half and looks like u hav lost water.undo the bolt on the top of the other rad and fill the rad up then run the engine till u can see the water movin around in side
it looks as if it is comeing down the over flow pipe because when you stop and put your hand to the end of the pipe it smells of coolant what could it be
mine does that 2, it leaks where the head and cylinder meet, u can check the bolts if they are tight enough, if they are u can buy head sealer at wal-mart it worked on mine...it fills the crack and puts a glass codeing over it
Leaking/Overflowing
If there are no signs of a leak externally, and its not boiling, maybe its leaking within the engine, which could be very bad.
I'd get a mechanic to look at it if you can't see where its coming out.
oil plug for crf150
I need to know what size socket to use on my oil drain plug. Is it a 22mm? what is it
Just grab a couple
Just grab a couple when you go to do it if you're not sure, say 21mm, 22mm and 23mm.
Once you know, you could stick some blue electrical tape around the outside of the sprocket so you know next time.
oil plug for crf150
that is the problem I don't have a couple I need to go buy one but I didn't want to buy a whole set right now Just thought maybe someone might own a crf150 and would know off the top of their head. Thanks anyway.
oil plug for crf150
Put a large crescent wrench on it and then measure the gap. Fold a piece of paper over it and measure the fold. Crawl under your bike with a metric ruler or lay it down and you know the rest.
that ought to do it for you.
Dave
seal
check your oil if it is white then u have a broken seal somewhere and thats where ya water is going...some times if u fill an emty rad it will only fill half cos and when u run it fills the other half and looks like u hav lost water.undo the bolt on the top of the other rad and fill the rad up then run the engine till u can see the water movin around in side
crf 150
how is your coolant leaking on a 150, they are air colled.
pipe
it looks as if it is comeing down the over flow pipe because when you stop and put your hand to the end of the pipe it smells of coolant what could it be
yz 125 coolant
check your water pump seal the same thing happened to mkine. they cost about twenty dollars at the yamaha shop
the water is most likely comi
the water is most likely coming through the water pump seal
ur water coolant leak
mine does that 2, it leaks where the head and cylinder meet, u can check the bolts if they are tight enough, if they are u can buy head sealer at wal-mart it worked on mine...it fills the crack and puts a glass codeing over it
i found out
i found out what the prob was my head gasket had gone there was a big hole in it so i got it replaced its fine now
bikes
is there eney 1 out there who has had a problem with an xr? no there bulitproof
bikes
is there eney 1 out there who has had a problem with an xr? no there bulitproof
xr
xrs rock